Friday, July 22, 2011

3D Vase

The vase is a circle that was cut across the bottom and then an oval punch was used to make the top of the vase.  To make the design on the vase, it was put thru the Cuttlebug to put the embossed strip across the top.  Edges were highlighted in green ink.  Pink flowers were made with small circles and layered.  White dots on flowers and vase is from Ranger Accents.  I like the 3D illusion that the vase is on a floor or counter and then you have the two side walls. 

4 comments:

Gerlinde said...

Love this! Is it like a pop up?

TerryH said...

No, not really a pop up. The vase was adhered with pop dots, but the illusion comes from the way the papers are cut at angles, so it looks like a corner of a room, or a corner of a table. Hope that makes sense?

Anonymous said...

What were your angles for each section of the wall and table. That one doesn't look so work intensive. I'd like to try it.
T

Terry said...

For the angles . . . well . . . . . .I sorta eyeballed it. I put the strip of paper on the right down (with the flowers), then put the dark green piece down on the left. Then the brown piece I cut the length of the card (4 1/4 inches) and cut as thick as you want it. Then cut off the corner - went from the left corner up to where the two green strips meet, cut at an angle. I sure do hope that makes sense? It is just really three pieces of paper and the brown is cut at the angle.